Diagram or photos of camshaft position sensor location....? - diagram photos of a sports hernia
04'Dodge Ram 1500 4.7 LI need to be replaced and can not find him. Any help would be appreciated.
Saturday, February 6, 2010
Diagram Photos Of A Sports Hernia Diagram Or Photos Of Camshaft Position Sensor Location....?
Subscribe to:
Post Comments (Atom)
The camshaft position sensor (CMP) in 4.7-liter V-8 engine is bolted to the front and top of the cylinder head right.
ReplyDeleteSAFETY FIRST!
1 Disconnect the electrical connector to CMP sensor
2 Remove the sensor mounting screws
Gyro-sensor, 3-cylinder head carefully
4 Check the condition of sensor O-ring
When the sensor again Insall:
1. Clean the machine hole in the ass
2 A small amount of engine oil sensor o-ring
3 Installation of the sensors in the cylinder head with a gentle rolling motion. The gyro-sensor is not in a position to the O-ring may cause damage
CAUTION: Before tightening the screws from the probe sensor is completely flush with the cap. If the sensor is flush to a damage sensor Tang assembly result in May.
4. Install and tighten the screws
5 Connect the power sensor